
A £6000 RTX 5090 nearly caught fire again after a warranty repair at Overclockers UK. - GameGPU
A Reddit user reported their £6000 Palit RTX 5090 graphics card nearly caught fire again after a warranty repair at Overclockers UK, with the replaced power connector found loose on the circuit board.
The graphics card, originally purchased in June 2025 for over £2000 but now valued at more than £6000, had previously suffered a melted 12VHPWR power connector when using the included NVIDIA adapter. After British retailer Overclockers UK accepted the card for repair under RMA, the owner discovered the replaced connector was physically loose on the printed circuit board upon return.
Diagnostic intervention
When first powering up the system with a Thermal Grizzly WireView Pro 2 diagnostic adapter, the device detected a critical current imbalance across the contacts and forcibly cut power to the graphics card at 0W, preventing another potential fire incident.
Warranty dispute resolution
After contacting customer support again, the buyer received notification that the warranty was voided due to physical damage to the connector. The owner examined service photos and argued the connector had fallen off due to poor cold soldering and a loose side retainer during the previous repair, citing the UK Consumer Rights Act 2015.
The copper contact pads and traces on the PCB remained intact, while the connector itself had fallen off due to poor cold soldering and a loose side retainer during a previous repair.
After the case gained traction in the r/pcmasterrace community, Overclockers UK management reviewed the service history and reversed the warranty voiding decision. The retailer confirmed a brand new RTX 5090 had been shipped to replace the defective unit, with the buyer confirming successful resolution of the dispute.