
The classic 8-pin connector on the 16GB GeForce RTX 5060 Ti melted under normal load. - GameGPU
A 16GB GeForce RTX 5060 Ti graphics card's classic 8-pin power connector melted during normal operation, causing the user's monitor to go blank.
The owner of a 16GB GeForce RTX 5060 Ti graphics card from Galax reported a serious problem involving a melted power cable. The issue occurred after the user's monitor went blank, revealing a charred auxiliary power connector upon inspection. This graphics card model has a stated power consumption of 180W and uses the classic 8-pin PCIe connector, previously considered more reliable than the modern 12VHPWR standard.
Incident Details
According to the report, the graphics card was purchased in October 2025 and paired with a 750W Ant eSports power supply. The device had been operating continuously under maximum load in standard mode without overclocking. The same power supply had previously powered a GeForce RTX 4070 graphics card without issues.
Photos of the damaged red connector show severe overheating signs, melted plastic, and carbon deposits on the top three contacts, with some remaining inside the connector on the graphics card itself.
Possible Causes
Ultimately, the accelerator owner decided not to risk a warranty claim, but plans to have the connector itself replaced at a service center and purchase a more reliable power supply.
Tech enthusiasts identified two main causes for the issue. The first is that the connector wasn't fully inserted into the graphics card connector, as indicated by a characteristic stepped carbon deposit on the connector housing, causing localized resistance and temperature increase. The second probable cause is the poor quality of components and cables in the budget power supply unit used.